Finn T30 HydroSeeder SD, Руководство по эксплуатации и каталог запасных частей

Страница: 22 / 49

16
3. With the engine at ¾ speed, open the remote valve at the end of the hose to discharge the load.
4. When finished spraying, close the remote valve, disengage (turn off) the clutch, and stop the engine.
If using fiber mulch, retain as much water as possible in the hose by elevating the ends or by cou-
pling the ends together.
5. If another load is to be done, see reloading procedure below. If finished for the day, follow the clean
up procedure and flush out the hose.
DANGER: The recirculation valve must be open when using a remote
valve. If not open, extreme heat which will cause damage
and/or bodily injury will occur.
RELOADING PROCEDURE:
1. Start at step 2 in loading procedure on page 13.
2. After last load of the day refer to the cleaning and maintenance section of the manual on pages
16-17.
CLEANING AND MAINTENANCE:
DAILY:
1. Cleaning the HydroSeeder®
A. Fill the slurry tank to the center of the agitator shaft with clear water.
B. Move agitator lever to full speed to flush off inside of tank top and walls.
C. Remove discharge nozzle and coupler gasket from the remote valve coupler at the end of the
discharge hose.
D. While aiming discharge toward an open area, open discharge and remote valve and engage
(turn on) the clutch. Allow to discharge until clear water is coming out.
E. Open the recirculation valve and allow to run until the stream is clear.
F. Disengage (turn off) the clutch, idle the engine, move discharge valve handle to discharge
position, move agitator handle to neutral and turn off the engine. (Remember to replace the
coupler gasket).
G. Always remove the drain plug and allow the tank to drain.
H. In freezing weather leave main tank drain plug out and remove pump drain plug. Move all
slurry valves to open position.
I. Wash the outside of the HydroSeeder® to remove any corrosive materials.
2. Lubricating the HydroSeeder® (see lube chart on page 18).
IMPORTANT: Lubrication should be performed IMMEDIATELY AFTER cleaning
of equipment. Engine not running.