Finn T30 HydroSeeder SD, Руководство по эксплуатации и каталог запасных частей

Страница: 14 / 49

8
PRE-START CHECK:
Safety check to insure operator safety:
1. A. Skid Unit - Check condition of all mounting hardware securing HydroSeeder® to truck
bed and frame rails.
B. Trailer Unit - Inspect hitch, safety chains, lights, brakes and breakaway switch.
2. Insure that all guards are in place.
EQUIPMENT CHECK:
CAUTION: Equipment check is made with the engine off and all rotating
parts stopped.
1. See that tool kit contains all the prescribed items (see tool kit list on page 41).
2. Inspect the “slurry-tank” for foreign objects. See numbers 2 and 3 in Maintenance Section (IV) of
the Safety Summary Section page 3.
3. Check fuel level.
4. Check the hydraulic oil level (see hydraulic system for oil specifications).
5. Check engine oil level . . . for oil type refer to the engine manual.
6. Inspect air cleaner for dust and dirt, clean if necessary.
7. Secure the tank drain plug in the drain pipe located in the center of the bumper.
8. Check to be certain pump drain plug is in place.
9. Lubricate equipment - See Lube Chart on page 18.
A. Each lubrication point is marked.
B. Check automatic pressure lubricator at pump. If the stem is fully extended with thumb nut all the
way up, the pressure lubricator contains lubricant - if not, lubricant must be replaced by the fol-
lowing procedure:
a) Turn thumb nut clockwise until stem rises to maximum height.
b) Remove cap and fill cap with sodium (water soluble) base grease. (FINN part number 000698).
Do not use lithium base (chassis lube) grease.
c) Replace cap.
d) Turn thumb nut counter-clockwise until the thumb nut is at the top of the stem. The spring and
pressure disc in the lubricator forces the grease, under pressure, to the pump seal.
IMPORTANT: When the thumb nut has moved down
to within ½” (1.25 cm) of touching the
cap, reservice the automatic lubrica-
tor.
Thumb Nut
Stem
Cap
Spring
Pressure Disk
Grease
FIGURE 1