Finn T30 HydroSeeder SD, Руководство по эксплуатации и каталог запасных частей

Страница: 10 / 49

4
the requirements of 29 CFR 1910.146. Including the
following:
a) Drain, flush and ventilate tank interior.
b) Turn off engine and disconnect battery cables
and perform lockout/tagout procedures. (29 CFR
1910.147)
c) Provide continuous ventilation or proper breath-
ing apparatus.
d) If tank must be entered, personnel entering the
tank must be tethered to a lifeline.
e) Provide stand-by individual outside of tank able
to communicate with person inside and able to
haul him out with lifeline if necessary.
4. Before loosening any
clamps or opening any
valves, determine if mate-
rial in the line is hot by
feeling the pipe. Do NOT
allow material to come in
contact with personnel.
Severe bodily injury could
result.
5. On trailer units perform general maintenance such
as checking the safety chains, hitch and hitch bolts,
tires, brakes. Repair or replace if worn or broken.
Never operate machine on improperly inflated or
damaged tires. Always use a safety cage or cable
restraints when re-inflating a repaired tire.
6. Battery maintenance: Lead-acid batteries contain
sulfuric acid, which damage eyes of skin on contact.
Always wear a face shield to avoid acid in the eyes. If
acid contacts the eyes, flush immediately with clean
water and get medical attention. Wear rubber gloves
and protective clothing to keep acid off skin. Lead
acid batteries produce flammable and explosive gas-
ses. Keep arcs, sparks, flames and lighted tobacco
away.
7. Filling of fuel: Never fill the tank with the engine
running, while smoking or when near an open flame.
Never smoke while handling fuel or working on the
fuel system. The fumes in an empty container are
explosive. Never cut or weld on fuel lines, tanks or
containers. Move at least 10 feet (3 meters) away
from fueling point before starting engine. Wipe off
any spilled fuel and let dry before starting engine.
NOTE: Be careful not to allow fuel, lubricant, hydrau-
lic fluid or cooling fluids to penetrate into
the ground or be discharged into the water
system. Collect all fluids and dispose of them
properly.
8. It is recommended that only authorized genuine
FINN replacement parts be used on the machine.
9. Diesel fuel or hydraulic fluid under pressure can
penetrate the skin or eyes and cause injury, blind-
ness or death. Pressure may build up in the hydraulic
system; use caution when removing the cap.
10. Make certain that all decals on the machine are
maintained in good legible condition. Replacement
decals are available through Finn Corporation by
specifying part number shown in the lower right hand
corner of the decal. See page 5 for the current safety
decals mounted on the unit. See pages 42-43 in
the Parts Manual for the location and quantity of all
decals on this unit.