Finn HydroSeeder T75, Руководство по эксплуатации и каталог запасных частей

Страница: 33 / 61

27
TROUBLE SHOOTING YOUR HYDROSEEDER®
:
Problem Probable Causes Suggested Solutions
Low engine RPM. Check throttle cable and linkage,
(Below 3600 RPM-No load) See authorized engine dealer.
Soft water. Slow agitator.
Too much agitation. Slow the agitator.
Pump worn. Reset pump tolerance page 23.
Suction partially plugged. Clean out machine see page 18.
Nozzle worn or plugged. Clean nozzles, replace if necessary.
Fertilizer. Change type.
VALVE:
Valve stuck. Frozen. Thaw out ice, lubricate. Leave in
discharge position during storage.
Constant plugging Foreign material in slurry. Drain and clean out tank. Check
during operation. storage for foreign materials.
Constant plugging Loading HydroSeeder® be- Reinstruct your operator. (See
during loading and fore tank is 1/2 full of water. page 15).
discharging.
Incorrect loading procedure. Review loading procedure page 15.
Improper operation by Reinstruct your operator. (Review
operator. Operator’s Manual).
Not moving valve handle Valve should be fully open.
far enough.
Machine not being flushed See page 15.
out prior to reloading.
Machine not being run at Reinstruct your operator. (See
correct RPM during loading. page 15).
Extension hose plugs Letting water run out, If hose has to be uncoupled, seal
after use. allowing fiber mulch ends to keep water in hose and
to dry out. prevent fiber mulch from
drying out.