Finn HydroSeeder T75, Руководство по эксплуатации и каталог запасных частей

Страница: 24 / 61

18
3. With the engine at ¾ speed, open the remote valve at the end of the hose to discharge the load.
4. When finished spraying, close the remote valve, disengage (turn off) the clutch, and stop the engine.
If using fiber mulch, retain as much water as possible in the hose by elevating the ends or by cou-
pling the ends together.
5. If another load is to be done, see reloading procedure on page 18. If finished for the day, follow the
clean up procedure and flush out the hose.
DANGER: The recirculation valve must be open when using a remote
valve. If not open, extreme heat which will cause damage
and/or bodily injury will occur.
III. DISCHARGE THROUGH THE BOOM (PLATFORM OPTION):
1. Move the clutch toggle switch to the “stand-by” position and close the recirculation valve. When
ready to discharge the slurry step on the clutch activation button on top of the platform, which
engages (turns on) the clutch. The slurry will discharge as long as this button is activated. To stop
the slurry simply remove foot from the button.
2. When the tank is empty, or when discontinuing discharge for an extended period of time, disengage
(turn off) the clutch and idle the engine. This will maintain moisture in the discharge piping and
help prevent plugging. Move the agitator control to the neutral position.
RELOADING PROCEDURE:
1. Start at step 2 in loading procedure on page 15.
2. After last load of the day refer to the cleaning and maintenance section of the manual on pages
18-19.
CLEANING AND MAINTENANCE:
AFTER FIRST 4 - 8 HOURS OF OPERATION:
1. Retorque wheel lugs - again after 7 days. (Trailer option only)(75 ft.lbs.).
DAILY:
1. Cleaning the HydroSeeder®
A. Fill the slurry tank to the center of the agitator shaft with clear water.
B. Move agitator lever to full speed to flush off inside of tank top and walls.
C. Remove discharge nozzle and coupler gasket from the remote valve coupler at the end of the
discharge hose (or the boom on the platform option).
D. While aiming discharge toward an open area, open discharge and remote valve and engage
(turn on) the clutch. Allow to discharge until clear water is coming out.
E. Open the recirculation valve and allow to run until the stream is clear.