Finn HydroSeeder T120, Руководство по эксплуатации и каталог запасных частей

Страница: 35 / 79

TROUBLE SHOOTING YOUR HydroSeeder
®
:
Problem Probable Causes Suggested Solutions
LEAKS:
Tank bearing Lack of lubrication - Replace seal and follow lube
leaks. seal worn. schedule.
Bolts not tightened. Tighten uniformly to 25 ft. lbs.
properly.
Pressure Clamps. Rubber seal cracked, Replace, always grease seal
pinched or torn. before clamping shut.
Suction. Rubber seal cracked, Replace, always grease seal
pinched or torn. before clamping shut.
Discharge Not greased often enough. Rebuild swivels w/repair kit (part
Swivels. #6969, 2 required).
Pump Shaft. Pressure lubricator not Replace pump seal, service
serviced. pressure lubricator daily.
Pump Suction Cover O-Ring bad. Replace cover O-Ring, use grease
Cover. when replacing.
Discharge Boom Worn or no gasket. Replace gasket.
or Nozzle Camlock
Fittings.
MACHINE JUMPS DURING OPERATION:
Agitator. Agitator bent by heavy Straighten agitator or shim, so it
object falling on it. runs true.
Bent Paddles. Loading wood fiber mulch Straighten agitator paddle, realign
into tank before tank is agitator to run true.
half full.
FOAMING OF SOLUTION AND LACK OF DISTANCE:
Pump looses prime - Sucking air in suction Check all suction connections to see
lacks distance - leaves lines. that rubber seals are in good shape.
excessive amount in Grease seals before replacing clamps.
tank (100 gal (378 liters)
or more).
Air entrainment. See page 30.
Low engine RPM. Check throttle cable and linkage,
(Below 2900 RPM-No load) See authorized engine dealer.
Soft water. Slow agitator.
Too much agitation. Slow the agitator.
Pump worn. Reset pump tolerance page 26.
31