Finn HydroSeeder T120, Руководство по эксплуатации и каталог запасных частей

Страница: 24 / 79

CAUTION: To decrease pump wear and increase discharge distance, it
may now be desirable to close the recirculation valve.
However, the recirculation valve must be open BEFORE
closing the discharge valve if the application of slurry is to be
interrupted. Extreme heat, which will cause damage and/or
bodily injury, will occur if both valves are closed.
16. Apply the slurry (see “Application of Slurry” pages 17-18).
17. If another load is to be applied, start again at step “1”. If finished, follow the clean-up procedure.
CLEANING AND MAINTENANCE:
AFTER FIRST 4 - 8 HOURS OF OPERATION:
1. Check and adjust clutch - see page 27.
2. Retorque wheel lugs - again after 7 days. (Trailer option only).
DAILY:
1. Cleaning the HydroSeeder
®
A. Fill the slurry tank to the center of the agitator shaft.
B. Move agitator lever to full speed to flush off inside of tank top and walls.
C. Remove discharge nozzle and gasket from discharge boom.
D. While pointing discharge toward an open area, move discharge valve handle to discharge
position and engage clutch. Allow to discharge until clear water is coming out.
E. Move recirculation valve handle to recirculation and allow to run momentarily.
F. Disengage clutch, idle the engine, move valve handle to discharge position, move agitator
handle to neutral and turn off the engine.
G. Always remove the drain plug and allow the tank to drain.
H. In freezing weather leave main tank drain plug out and remove pump drain plug. Move all
slurry valves to open position.
I. Wash the outside of the HydroSeeder
®
, including the radiator, to remove any corrosive
materials.
J. If using lime - the daily maintenance should be performed after every load.
K. Cleaning out extension hoses.
2. Lubricating the HydroSeeder
®
(see lube chart pages 22-23).
IMPORTANT: Lubrication should be performed IMMEDIATELY AFTER cleaning
of equipment. Engine not running.
A. Lubricate the agitator shaft bearings located on the outside front and rear of the slurry-tank.
B. Service the automatic lubricator on the pump as needed (for service see page 9).
C. Check the engine oil and replenish when necessary. Change oil and filter after first 50 hours
then 75 hours thereafter. Consult the engine operator’s manual for the correct grade of oil and
the engine break-in procedure.
D. Lubricate the swivel on the discharge assembly.
20