Finn HydroSeeder T120, Руководство по эксплуатации и каталог запасных частей

Страница: 9 / 79

5
CURRENT SET OF SAFETY DECALS
Before entering the tank:
1. Drain, flush and ventilate
tank interior.
2. Turn off engine and disconnect
battery cables.
3. Provide continuous ventilation
or proper breathing apparatus.
4. Provide standby individual
outside of tank able to communicate
with person inside and able to haul
him out with lifeline if necessary.
P/N 8097
Never operate pump with
both recirculation and
discharge valves closed.
Do not use remote valve
unless recirculation valve
is open. Excessive heat or
bodily injury will occur.
P/N 5216
Do not aim stream
into high voltage
lines.
P/N-11567
Before loosening
any clamps or
opening any valves,
determine if
material in line
is hot. Do not
allow material to
come in contact
with personnel.
P/N 8209
HOT EXHAUST
012278
23423
BREAKAWAY SWITCH
Do not use for parking.
Attach cable to towing
vehicle with slack for
turning. Engine battery on
trailer must be charged
and hooked up for proper
breakaway function.
12251
Rotating fan hazard.
Keep hands clear.
Shut off engine
before servicing.
12179
Do not operate
without guards
in place.
22357
Turn engine off,
disconnect battery,
and allow all moving
parts to stop before
servicing equipment.
012279
To prevent serious burning or scalding:
• Pressurized cooling system.
• Allow system to cool.
• Remove cap slowly with gloves on.
P/N 11569
THIS CONNECTION
FOR REMOTE AND
HOSE REEL ONLY -
USE DISCHARGE GUN
FOR NON REMOTE
VALVE WORK.
SEE OPERATOR'S
MANUAL
23519
Wear eye protection
around operating
equipment.
CAUTION!
USE ON 2-5 / 16"
BALL ONLY
P/N 5022
20970
Personnel should not
ride this equipment
at speeds greater than
5 MPH (8 km/h).
20970
Both the single and double chains must be crossed
under the tongue. They must be oriented in such a
manner as to prevent the tongue from dropping to the
ground in the event of failure to the hitch, coupler or ball.
The chains must be connected to the towing vehicle so
that the slack for each length of chain, between the
trailer and the towing vehicle, is the same and must
have no more slack when in use than is necessary to
permit proper turning of the vehicles. The forward end
of the chain must be attached to the towing vehicle,
not
to the ball, but to the hitch or other frame member. The
chain must be looped around the member and hooked
back into itself.
SAFETY CHAIN INSTALLATION
P/N-80107
Always use step
when mounting and
dismounting. Do not
ride on hitch when
vehicle is moving.
P/N-31227
Always inspect tow
vehicle and equipment
hitch before towing.
Tighten all hitch
bolts and properly
connect wiring and
safety chains.