42
To setup the Access Control:
Press Menu icon
>
Access Control
>
Access Control Options
• Gate Control Mode
Select to turn on the gate control mode. If ON is selected, the interface will remove
the Door lock relay, Door sensor relay and Door sensor type function.
• Door Lock Delay(s)
This value is the time period for the door to lock again after it unlocks on successful
verification. Valid value: 1-10s; 0s represents function disabled.
• Door Sensor Delay(s)
This function only works if the door sensor is available. When a door is not closing
for a specified time, the sensor will trigger the alarm system. Specify the time of the
delay. The valid value of Door Sensor Delay ranges from 1 to 255 secs. Choose your
preference.
• Door Sensor Type
There are three types of door sensor available for door access which are None, Nor-
mal Open (NO), and Normal Closed (NC). Once a door sensor is available, you have to
choose the door sensor type. Dault is None.
• Verification Mode
The supported verification mode includes password/face, User ID only, password,
face only, and face + password.
• NC Time Period
To set the time period for Normal Closed mode, so that no one can gain access dur-
ing this period.
• NO Time Period
To set the time period for Normally Open, so that the door is always unlocked during
this period.
• Speaker Alarm
When the ‘Speaker Alarm’ is enabled, the speaker will raise an alarm when the device
is being dismantled.
• Master Device
The status of the master can be set to exit on enter when setting up the master and
slave terminals.
Exit:
The record verified on the host is the exit record
Enter:
The record verified on the host is the entry record
• Reset Access Settings
To restore access control parameters. However, erased access control data in Data
Mgt. is excluded.
