Finesse VCS -F-B-10E, Руководство по эксплуатации, Страница: 8 / 55

Check before putting the air curtain into operation, if the following preconditions of the installation are fulfilled:
- Installation conforms with the conditions of “Safety and air curtain operation conditions” chapter
- Mechanical installation conforms with the conditions of “Installation” chapter
- Electrical installation conform with the conditions of “Electric connection of air curtain” and “Controller connection“
chapters.
- In case of air curtain equipped with water heat exchanger also the conditions listed in chapter “ Water heater
connection” must be kept.
- Operators of the air curtain must be trained and received the Maintenance and operation manual.
PUTTING THE AIR
CURTAIN INTO
OPERATION
POSSIBILITIES OF THE
SINGLE CONTROL
SYSTEMS
12 /0 9 page 08
SM DM DA
Two steps of heating output
(electric version)
Possibility of door contact connection
Room thermostat connection
Filter clogging signal (presostat)
Electric heater overheating signal
Possibility to chain up to 6
air curtains together
YES
YES YES
NO
NO
NO
NO
NO
NO
NO
YES* YES
YES
YES
YES* YES
YES* YES
YES YES
YES YES YES
Three steps of fan speed
Time switch connection
Outdoor temperature sensor
YES
YES*
YES*
YES *
°C
ALARM
FILTER
1 2..
*Just one of the temperature sensors
°C
OPERATION MANUAL
°C
Time switch is used to switch the air curtain ON /
OFF according to the pre-set time schedule. The
time schedule can be set for the all office days in
the week. Switch can be fixed to the DIN-batten
and it is recommended to put it somewhere into
the switchboard. Time switch must be powered by
a separate connection. For detailed information on
the setting of the switch and its programming see
“Time switch controlling”.
Time switch SH
Temperature sensor follows the outdoor
temperature and provides this information to the
electronic system, which controls the air curtain
accordingly in the automatic mode. This sensor is
delivered, including the interconnection cable, to
DA control system only, it is a standard part of
delivery. For detailed description of the function see
“Operation DA control system”.
Outdoor temperature sensor
- potential-free contact with maximum voltage 12 V
- two-wire cable of 1,5 mm cross section
- maximum length of the cable 50 m
- time switch power supply cable three-wire
of 1,5mm diameter, 230V / 50 Hz
- potential-free contact with maximum voltage 12 V
- three-wire cable of 0,35 mm cross section
- maximum length of the cable 5 m
(standard part of DA control system delivery)
- 17 - silver wire
- 18 - red wire
- 19 - white wire
Time switch for
(DM), DA
Time switch for SM
1 2
22 23
Outdoor temperature sensor
17 18 19
PE
OPERATION INSTRUCTIONS
1
1 2
DK DK
20 21
( (