DAILY MAINTENANCE
REPLACEMENT OF THE SQUEEGEE RUBBER
If the squeegee rubber is worn and does not dry well, it is possible to change
the drying edge proceeding as follows:
1.
Push and rotate the fixing plates
2.
Slip off the rubber blade and the rubber itself
3.
Turn the rubber upside-down and if necessary, replace it
4.
Adjust the squeegee height as indicated in “ADJUSTMENT HEIGHT
SQUEEGEE SUPPORT” under “MACHINE PREPARATION”
5.
Reassemble everything repeating inversely above operations
DISASSEMBLY OF THE BRUSHES
1.
Connect the battery connector, if it is not connected
2.
Turn the key into position ON
3.
With the manipulator lower the brushes base until it almost touches the
floor (do not lower completely)
4.
Turn the key into position OFF and take it off from the instrument board
(to carry out the operations of brushes disassembly with connected current
can cause damage to the hands)
5.
Loosen the knobs (1) as shown in the figure
6.
Extract the bases by sliding them
7.
Lift the bases using suitable equipment both for their weight (60kg) as for
their coupling type (see the apposite labels)
8.
With the brushes base in lifted position, rotate the brush until it comes off
from the brush plate seat as shown in the figure. The figure shows the
rotating direction for the disassembly of the right brush, the left one has to
be rotated inversely.
55
