MACHINE PREPARATION
8.
SQUEEGEE
The squeegee, which is packed separately from the machine, should be
assembled as shown in the figure, couple the screws (1) of the squeegee into
their seats on the squeegee support and fix them with a key CH17.
Fit the suction hose (2) into its coupling and fix it with the appropriate clamp.
During working operation, the rear rubber has to work slightly tilted
backwards and this equally in its whole length for about 5 mm.
If it is necessary to increase the rubber bending in the central part, then tilt
the squeegee body backwards, loosen the lock nut (2) and tighten the screw
(1). If the rubber bending is to be noticeable at the sides of the squeegee,
loosen the lock nut (2) and unscrew the screw (1). After regulations have been
done fix the lock nut. These operations have to be done with the help of a key
CH13.
9.
ADJUSTMENT HEIGHT SQUEEGEE SUPPORT
The squeegee has to be regulated in height depending on the wearing of the
rubbers. To adjust this:
1.
Loosen the ring nut (1)
2.
With a key CH17 rotate the castor wheel through the nut (2) clockwise to
lift the squeegee and counterclockwise to lower it
3.
Fix the ring nut (1)
NOTE: The right and left castor wheels have to be regulated equally.
42
