Fimap ENJOY 360, Настройки, Страница: 7 / 8

ADJUSTMENTS AND
INSPECTIONS
ENJOY 360
Doc. 10005053
Issued 12/2006
Rev. 00
Page 7 of 8
2. If necessari, loose the lock nut of the ring rod to
increase or decrease the height of the squeegee.
Adjusting the Squeegee
1. Check the height of the central wheels and adjust
them as necessary using the M8 self-locking nut ,
so that the rubber on the floor has a uniform
inclination on the sides and in the center. Unscrew
to lower the wheel support and screw tighten to lift
it.
2. Use the two knobs to adjust the inclination of the
squeegee:
 Unscrew the lock nut ;
 Adjust each knob so that the rubber along its entire
length is not too crushed against the ground or too
lifted but has an approximate 30° inclination.
 Tighten the lock nut.
3. Adjusting squeegee pressure: use the knob ,
screwing it to increase pressure and unscrewing it to
decrease pressure.