Filtec Omnivision 1000 Series, Руководство по установке обновления

Страница: 28 / 70

20 Omnivision Upgrade Installation Manual
Document 45277-0805
Red Harness P/N 45262
(Packed in Upper Cabinet Kit P/N 45251)
The Red Harness references a point called the “First Breakout”.
This position on the cable has a special designation and should be
located first. The First Breakout position will be placed on top of
the starting point in the upper cabinet. This starting point is
shown in the following figure:
Separate two cables, 45211 (SW3-P1) AND 45211 (PL2-J3) from
the rest of the Red harness. These cables will go down the white
column along with the white harness.
Lay down the harness and align the starting point with the first
breakout and route the harness as shown above.
Set aside the cable that has been routed and lay the cable on a
clean surface. The cabling will be routed in the base cabinet
along with the other harnesses’.
FIRST BREAK OUT
11”
7.5”
RED HARNESS
RED COLUMN