Fiessler RAZL-2 CO, Руководство по установке

Страница: 53 / 84

Commissioning of a main column (master / single unit)
Commissioning via the setup wizard is only possible if the device is new or has previously been reset to
the factory settings. "Activate factory setting"on page68
Setting up a WLAN connection
Make sure that the RAZL-2 CO you want to configure is ready to use.
To log on to RAZL-2 CO, you need the network name and password. For factory-set devices, the fol-
lowing Wi-Fi settings are active:
l
WLAN name (SSID): RAZL serial number of the sensor column (the serial number is located on
the type plate of the sensor column)
l
Wi-Fi password: fiessler#razl
1. Open the overview of the available Wi-Fi networks on the device with which you want to con-
figure the RAZL-2 CO .
2. Connect to the Wi-Fi of the RAZL-2 CO you want to configure.
3. You may see a message on your device that there is no Internet connectivity over the new con-
nection. It must be selected to keep the Wi-Fi connection.
If you use a smartphone for configuration, you will no longer be able to connect to the mobile
device until the connection to this Wi-Fi network is stopped.
Operating mode RAZL-2 CO main column
Info: The operating mode can only be changed if the device is set to factory setting.
1. To start the Setup RAZL-2 CO Wizard, open a new window in your Internet browser. Enter