Fieldmann FZS 1001-A, Руководство пользователя

Страница: 14 / 18

15
USER‘S MANUAL CORDLESS GRASS TRIMMEr
EN Operation
7. OPERATION
Grip rear handle and press trigger lock-off button (A) with thumb then pull trigger switch (B)
(see pic 6). Switch off the trimmer by pulling of the trigger switch.
Turning on the machine
Before starting the grass trimmer for the first time, check that the nylon lines touch or pass
over the wire cutting blade. If they are not long enough:
- Press the spool button (see pic 7)
- Pull more nylon wires to lengthen. (see pic 7)
The lengthened nylon line will be cut to size automatically by the wire cutting blade once the
lawn trimmer is turned on.
During use, the nylon line will become shortened or worn. To automatically lengthen or
advance the nylon cutting line, tap the spool button lightly on ground (while the unit is
running). (see pic 8)
These operations should be repeated a few times before starting work to make sure that
everything is functioning properly and to familiarize yourself with the grass trimmer. Start off
slowly, when you have gained experience, you will be able to use the grass trimmer to its full
potential.
The length of the grass trimmer can be infinitely varied and therefore adjusted to your
individual height (see pic 9)
- Hold the tube with one hand, and then loosen the adjusting bolt.
- Set the handle to the correct length and tighten the adjusting bolt.
Replace the spool of nylon line
Switch off the trimmer and wait for all parts to stop moving.
Remove the battery pack.
Remove the spool assembly from the trimmer. To do so, hold the outer ribbed part of the
assembly with one hand, while pushing down and turning the spool head with the other to
unlock it (see pic 10). The spool carrier and spool will now disassemble easily.
Note :
There is a spring inside the head that could easily be lost. Ensure that it is put in a
safe place.
Choose either OPTION 1 or OPTION 2 below for spool or line replacement.
- OPTION 1: ACCESSORY REPLACEMENT SPOOL
Use replacement spool
Insert the line through the eyelet in the spool carrier and slide the spool into it. (see pic 11)
Making sure to insert the spring, assemble the spool and spool carrier back onto the trimmer.
To do so, push the head on and turn it clockwise until it locks. (see pic 12)