Fieldmann FZS 1001-A, Руководство пользователя

Страница: 15 / 18

FZS 1001-A
16 EN Operation
To test if the line is advancing properly, push the button with your thumbs while pulling the
wire with your fingers. The line should advance freely.
- OPTION 2: REWINDING SPOOL USING LINE
To install line, follow the steps below:
- Insert one end of line into the hole in the spool as shown in picture 13 about 3 mm.
- Snugly and evenly wind the line onto the spool in the direction of the arrow on the spool
(see pic 13), until the line builds up to the notches in the spool rim. Do not overfill spool.
The spool holds about 6.5 m of line.
Note :
Line for your trimmer is available at extra cost from your local dealer.
Charging the battery
(see pic 14)
The battery needs to be charged before first use and whenever it fails to produce sufficient power
on jobs that were easily done before. The battery may become warm while charging; this is
normal and does not indicate a problem.
Note:
After several charge and discharge cycles, the battery will attain full capacity.
Note:
DO NOT CHARGE THE BATTERY AT AMBIENT TEMPERATURES BELOW 4ºC OR ABOVE
40ºC. RECOMMENDED CHARGING TEMPERATURES: APPROX. 24ºC.
Connect the charger (2) to the charger station (3).
Plug the charger into an appropriate AC power outlet. The LED (4) lights green to tell you that
the charger is ready for use.
Insert the battery pack (1) into the charger station (3) as shown in picture 13. Make sure the
battery pack is fully seated in the charger station. The LED (4) lights red to tell you that the
battery pack is on charge.
The battery pack will be fully charged in about 4 hours. And the LED (4) lights green again to
tell you that the battery pack is fully charged.
Important charging notes
Note:
Longest life and best performance can be obtained if the battery pack is charged
when the air t
emperature is between 18-24°C. Do not charge the battery pack in a very low
or very high air temperature. This is important and will prevent serious damage to the battery
pack.
When using your tool continuously, the batteries in your battery pack will become hot. You
should let a hot battery pack cool down for approximately 30 minutes before attempting to
recharge
The charger and battery pack may become warm to touch while charging. This is a normal
condition, and does not indicate a problem.
Use the charger in normal room temperatures whenever possible. To prevent overheating, do
not cover the charger and do not charge battery packs in direct sunlight or near heat sources.