Fieldmann FZD 5015 E, Руководство пользователя

Страница: 14 / 88

EN 14
FZD 5015 E
Setting up and working with the shredder
8. SETTING UP AND WORKING
WITH THE SHREDDER
Setting the counter-blade distance
For effective operation, it is necessary to set the
distance between the counter-blade (Fig. 8, point
2) and the cutting roller (Fig. 8, point 3). The gap
between the cutting roller and the counter-blade
should be as small as possible.
A correct setting will enable the effective shredding
of all branch diameters.
Setting the distance:
Turn on the machine.
To pull the counter-blade towards the cutting
roller, slowly turn the setting screw (Fig. 8, point 1)
clockwise. Keep turning the screw until fi ne aluminium fi llings start falling out of the ejection chute.
NOTE: Soft material or wet branches may be torn instead of being cut. This problem may also be caused by
the counter-blade, which wears out after frequent use.
Before turning on
Make sure that:
Power cords are not damaged. If there are slits or cracks on a power cord, stop work and replace it
immediately.
The machine is not damaged and all the screws are pulled tight.
The machine is completely and correctly assembled.
Check the power supply:
Make sure that the supply voltage corresponds to the rated voltage on the rating label and that the machine
is properly grounded.
Only use extension cords that have wires with a suffi cient cross-section.
Material that the shredder can process
The shredder can process the following types of materials:
All types of branches up to the maximum diameter specifi ed in the technical specifi cations.
Garden waste such as wilted plants or wet grass (shred alternatively with branches).
The shredder MUST NOT process the following types of materials:
Glass, metals, plastics, rocks, ceramics, branches thicker than specifi ed in the technical specifi cations, hard
wood, thick wooden boards, fabrics, plastic bags, roots with soil.
Wastes that are almost in liquid form, e.g. kitchen scraps.
Fig. 8
1
2
3