Fieldmann FZD 5015 E, Руководство пользователя

Страница: 16 / 88

EN 16
FZD 5015 E
11. TROUBLESHOOTING
WARNING: Prior to troubleshooting, turn the machine off, disconnect it from the power supply and wait for
it to come to a complete stop.
Problem Possible cause Remedy
The motor will not start
No power supply Check the power supply.
Faulty power cord
To check, inform yourself at an authorised
service centre
Fuse against overloading was activated
Wait until the machine cools down and
press the fuse button.
The collection box safety lock (the
collection box is unlocked)
Check and lock the collection box
The motor can be heard, but is
not working
The cutting roller is blocked
Turn off the machine.
Switch the forward/reverse switch to
reverse rotation.
Turn the machine on until the blockage is
cleared.
Again turn the machine off.
Switch back to the forward rotation.
Malfunction of a capacitor
Take the machine to an authorised service
centre for repair.
The shredded material is not
being pulled into the shredder
The reverse rotation direction is set.
Turn the machine off and switch the
rotation direction using the switch.
The shredded material is jammed in the
fi lling funnel
Turn the machine off. Switch the forward/
reverse switch to reverse rotation. Turn
on the machine to release the shredded
material, remove undesired material.
Turn the machine off again.
Switch back to the forward rotation.
The shredded material is too soft or wet Push the material into the shredder
Incorrectly set counter-blade / cutting roller
Set the counter-blade as described in
"Setting up and working with the shredder".
In the event that the cutting roller / counter-
blade is heavily worn out, replace it.
The shredded material is not
cleanly chopped up
The counter-blade is not set properly
Set the counter-blade as described in the
previous paragraph
The machine turns on but is
blocked even by a small load
and is soon shut off by the motor
protection switch.
The extension cord is too long or the cross-
section of its wires is too small.
The power socket is too far from the power
source or the cross-section of the wires in
the power cord is too small Check that the wire cross-section of the
extension cord is at least 1.5 mm
2 , and no
longer than 25 m. If a longer power cord is
used then the minimum wire cross-section
is 2.5 mm
2
Troubleshooting