S.CON1M TX/FX Managed Converter
20
15. Jumpers usage for Fault Propagation
References:
Page 16 (DIP SWITCHES CONFIGURATION)
Page 17 (FAULT PROPAGATION MECHANISM)
Page 28 Management section (Figure 9 – terminal: device control menu)
Fault Propagation setup
Normally the DIP switch S5 is in FP disable mode (Down) prior to the installation.
After having established the F/O and TP links and verified that the SNMP management
module is working properly, you may set the Fault Propagation to the required mode
(F>T and/or T> F)
DIP switch S5 in UP position will enable both F>T and T>F.
By means of the management you may enable/ disable F>T and/or T>F.
The setting through the management will override the DIP switch S5 and vice versa.
IF it is necessary to disable permanently
the FP modes of operation : F>T and / or T>F
You may use the jumpers J1 and J2
See the drawing below (by default the jumpers are open= FP enable)
Note: The jumpers setting should be carried out only by Technical Support staff. Disconnect
the power from the unit before setting the jumpers.
Warning: opening the product's case may annul warranty. If you wish to
change setting as described here, you must obtain permission in writing
from FibroLAN Customer Support Organization prior to doing so.
Permission will be specific to a service engineer and to units (identified
by serial numbers).
