6 Appendix
Copyright © Fibocom Wireless Inc.
71
by the USI, or the host manufacturer can take responsibility through the change in FCC ID
(new
application) procedure followed by a Class II permissive change application.
End Product Labeling
When the module is installed in the host device, the FCC ID label must be visible through
a window on the final device or it must be visible when an access panel, door or cover is
easily re-moved. If not, a second label must be placed on the outside of the final device
that contains the following text: “Contains FCC ID: ZMOLC116LA”
The FCC ID can be used only when all FCC/IC compliance requirements are met.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna
and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) Only antennas of the same type and with equal or less gains as shown below may be
used with this module. Other types of antennas and/or higher gain antennas may require
additional authorization for operation.
In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC/IC authorization is
no longer considered valid and the FCC ID/IC ID cannot be used on the final product. In
these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC/IC authorization.
Содержание LC116-LA
Страница 1: ...LC116 LA Hardware Guide V1 1...
