FIBER FOX Mini 6S+, Руководство пользователя

Страница: 17 / 49

15
3.6 Preparing the Fiber
3 steps should be carried out before splicing:.
1.Stripping
Remove at least 50mm of secondary coating (valid for both tight and loose tube
secondary coating) and approximately 30~40mm of primary coating with an
appropriate stripper.
Note : always remember to slip a
heat-shrinkable sleeve onto either
end of the fibers at the beginning
of each fiber preparations.
2．Clean bare fibers with pure alcohol-soaked gauze or lint-free tissue.
3. Cleave the fiber
In order to ensure the best splicing result, cleave the fibers with high quality cleaver
such as DC-09 fiber cleaver, and strictly control the cleaving lengths shown as
below.
Important!
From this moment, you must be very careful with the fibers to ensure that they do
not become dirty again.(For example, avoid putting them down on a dusty working
surface, or even waving them around in the air). Also check if the V-grooves are
clean, if not, wipe them clean.
Examples of cleaving lengths
primary coating
use blue V-grooves
(Clamping on bare fiber)
tight secondary
coating