Fiat Qubo, Руководство пользователя

Страница: 34 / 196

Removing the rear seat
The rear seat can be removed to carry
large loads and expand the boot even
further. Operate the two brackets A
fig. 57 under the side of the seat (one
on each side) after having tipped the
rear seat as previously described.
Repositioning the rear seat
Proceed as follows:
check that the seat belt webbing is
correctly inserted in the corresponding
bracket:
take the cushion back to horizontal
position and check that it is secured
correctly;
tip back the backrest and check that
it is secured correctly.
A pictogram fig. 58 is located under the
split seat cushion showing how to
secure the seat back onto the brackets
screwed to the floor.
WARNING
21)
If you are travelling in areas with few
filling stations and you want to transport
fuel in a spare tank, comply with the law by
using only an approved, suitably secured
tank. In the event of a collision the fire
risk is increased all the same.
22)
Never exceed the maximum allowed
load in the boot (see "Technical
Specifications" section). Also make sure
that the objects you place in the luggage
compartment have been properly secured,
to avoid them from being thrown forward
consequent to sudden braking and injuring
your passengers.
23)
The spring-loaded system is designed
for optimum usage. Accidental knocks
or a strong gust of wind may release the
springs, forcing the doors to close.
24)
When closing, shut the right-hand door
2 fig. 45 fully before you close the left-hand
door 1 fig. 45. Never shut the two doors
at the same time.
25)
You must not use the folded rear seat
to carry luggage. The load could be thrown
forward into the backrest of the front
seats, seriously injuring the occupants.
26)
Do not try to close the tailgate by
pressing on the side shock absorbers C fig.
43
. Also be careful not to knock the side
shock absorbers when you load the boot,
to avoid damaging them.
57
F0T0455
58
F0T0302
32
KNOWING
YOUR
VEHICLE