Enhanced Accident Response System
In the event of an impact, if the communication network remains intact, and the power
remains intact, depending on the nature of the event, the ORC will determine whether
to have the Enhanced Accident Response System perform the following functions:
•
Cut off fuel to the engine
.
•
Flash hazard lights as long as the battery has power or until the hazard light button is
pressed
.
The hazard lights can be deactivated by pressing the hazard light button
.
•
Turn on the interior lights, which remain on as long as the battery has power or for
15 minutes from the intervention of the Enhanced Accident Response System
.
•
Unlock the power door locks
.
Enhanced Accident Response System Reset Procedure
After the event occurs, when the system is active, a message regarding fuel cutoff is dis-
played
.
Turn the ignition switch from ignition AVV/START or MAR/ACC/ON/RUN to igni-
tion STOP/OFF/LOCK
.
Carefully check the vehicle for fuel leaks in the engine compart-
ment and on the ground near the engine compartment and fuel tank before resetting
the system and starting the engine
.
Depending on the nature of the event the left and right turn signal lights, located in the
instrument panel, may both be blinking and will continue to blink
.
In order to move your
vehicle to the side of the road, you must follow the system reset procedure
.
Customer Action
Customer Will See
NOTE:
Each step MUST BE held for at least two seconds
1
.
Turn ignition STOP/OFF/LOCK
.
(Turn
Signal Must be placed in Neutral State)
.
2
.
Turn ignition MAR/ACC/ON/RUN
.
Right turn light BLINKS
.
Left turn light is OFF
.
3
.
Turn right turn signal switch ON
.
Right turn light is ON SOLID
.
Left turn light BLINKS
.
4
.
Place turn signal in neutral state
.
Right turn light is OFF
.
Left turn light BLINKS
.
5
.
Turn left turn signal switch ON
.
Right turn light BLINKS
.
Left turn light is ON SOLID
.
6
.
Place turn signal in neutral state
.
Right turn light BLINKS
.
Left turn light is OFF
.
7
.
Turn right turn signal switch ON
.
Right turn light is ON SOLID
.
Left turn light BLINKS
.
8
.
Place turn signal in neutral state
.
Right turn light is OFF
.
Left turn light BLINKS
.
9
.
Turn left turn signal switch ON
.
Right turn light is ON SOLID
.
Left turn light is ON SOLID
.
GETTING STARTED
33
