Festool TURBO II M - 14 WP, Оригинальное руководство по эксплуатации

Страница: 24 / 117

24
Turbo II M
GB
Other failures
8 Settings
The following settings can be made using the but-
tons:
F4 Temp. high Temperature in motor terminal box
too high. Reduce ambient temperature., pro-
vide better cooling.
Contact service if fault occurs again.
F5 Temp. low Device temperature too low. Increase ambient temperature
Contact service if fault occurs again.
F6 Temp. sen-
sor Temperature sensor in terminal box
defective. Contact Service.
F7 Pressure
sensor Pressure sensor defective Check/ replace vacuum hoses.
Contact service if fault occurs again.
F8 Controlunit Control unit fault Contact Service.
F9 Electronic Electronic fault Contact Service.
F10 Control Fault message from FC. Contact Service.
F11 Power Sup-
ply on Fault with the power supply Check/ replace fuses.
Contact service if fault occurs again.
F11 Power Sup-
ply off Fault with the power supply Check/ replace fuses.
Contact service if fault occurs again.
F12 Temp. high Temperature of blower nozzle too
high Reduce ambient temperature., pro-
vide better cooling.
Contact service if fault occurs again.
F13 Calib. P Fault with pressure sensor calibration Try to restart.
Contact service if fault occurs again.
F14 Temp. sen-
sor Temperature sensor at blower nozzle
defective. Contact Service.
F15 On-Button Button faulty ON-Button Contact Service.
Failure code
E Failure D Significance Solution
Failure Cause Solution
No function Mains supply defective
Fuses have tripped
ground fault circuit interrupter has
tripped
Check, repair if necessary.
No / poor dedusting function Air pressure to low Check vacuum hoses.
Increase air pressure.
Check solenoid valves Contact Service.
Fuses defective Check, replace if necessary (see
chapter 10.5).
No / poor extraction Internal hose rupture Contact Service.
Leakage at the trap or pipe system Check.
[1-2] Operating buttons
[1-4] Return key
[1-5] Enter key