Festo SFC-DC series, Руководство пользователя

Страница: 89 / 202

5. Commissioning
5−5
Festo P.BE−SFC−DC−IO−EN en 0801a
For commissioning an axis formed of the SFC−DC and a drive
(e.g. type SLTE−...), the mechanical composition must be
configured (type of drive) and a measuring reference system
(referencing and reference coordinates) must be defined. By
means of the measuring reference system, all positions are
defined and movement can be made to them, e.g. with a posi
tion set from the position set table.
·
Switch on the power supply for the SFC−DC.
When the power supply is switched on, the SFC−DC auto
matically carries out an internal check.
Warning
Danger of injury.
Faults in parametrization can cause injury to people and
damage to property. In the following cases a reference run
is absolutely essential in order to set the reference coordi
nates and the working range correctly:
during initial commissioning,
when the referencing method is changed,
after each time the logic voltage supply is switched on!
·
Check (if your drive has been configured at the factory)
the settings in the menu [Diagnostic].
·
Carry out parametrizing and commissioning with the con
trol panel or the Festo Configuration Tool, as described in
the following chapters and in the Festo Configuration
Tool/PlugIn help.
Explanations of reference coordinates and the working
area can be found in Section 1.1.3.
·
In order to complete commissioning note the instructions
for operation in the Festo Configuration Tool/PlugIn help
and in section 5.7.