Festo MPA-L Series, Описание

Страница: 121 / 160

5. Conversion and maintenance
5−21
Festo P.BE−MPAL−EN en 1008NH
5. Secure the Sub−D socket with the two screws, Torx size 6,
in the cover, by initially hand−tightening the two screws
and then loosening by a half−turn.
This ensures that the multi−pin plug and socket are
aligned with each other on assembly.
6. Screw the cable connector from the outside onto the
internally situated M20x1.5 nut and tighten the cable
connector with an open end spanner, size 24 (torque
2.2Nm ±10%).
7. Screw the cover nut onto the cable connector, hold it
securely with an open end spanner, size 24, and tighten
the cover nut (torque 3Nm ±10%).
8. Screw the locking screw M20x1.5 in the open front face
hole and tighten it (torque 1.2Nm ±10%).
9. Secure the cover to the left−hand end plate with the four
screws provided (Torx, size10, torque 1.2Nm ±10%).
Conversion to straight cable outlet
When you have carried out the preparatory work proceed as
follows:
1. Loosen the locking screw M20x1.5 and remove it from the
cover.
2. Place the M20x1.5 nut from the inside in the rotation
protection of the cover.
3. Insert the M20x1.5 locking screw from the outside in
the side opening of the cover, secure it with the M20x1.5
locking screw and screw tight the cable connector (torque
3Nm ±10%).
4. Guide the multi−pin cable through the M20x1.5 locking
screw and out through the cover.