Festo CP Factory, Оригинальная инструкция по эксплуатации

Страница: 14 / 90

Fundamental safety instructions
14
© Festo Didactic 8065842 en
4.4 Pneumatic components
WARNING
•
Depressurize the system!
– Switch off the compressed air supply before working on the circuit.
– Check the system using pressure gauges to make sure that the entire circuit is
fully depressurized.
– Please note that energy may be stored in reservoirs. Further information on this
issue is available in the datasheets and operating instructions included with the
components.
•
Risk of injury when switching on compressed air!
Cylinders may advance and retract automatically.
•
Risk of accident due to advancing cylinders!
– Always position pneumatic cylinders so that the piston rod’s working space is
unobstructed along its entire stroke range.
– Make sure that the piston rod cannot collide with any of the rigid components in
the setup.
•
Risk of accident due to pneumatic tubing slipping off!
– Use shortest barbed tubing connectors possible.
– If pneumatic tubing slips off, switch off the compressed air supply immediately.
•
Do not exceed the maximum permissible pressure of 600 kPa (6 bar).
•
Do not switch on the compressed air until all the barbed tubing connectors have
been connected and secured.
•
Do not disconnect pneumatic tubing while it is under pressure.
– Do not attempt to seal or plug pneumatic tubing or plug connectors with your
hands or fingers.
•
Check the condition of the condensate in the service unit regularly. If necessary,
drain the condensate and dispose of it properly.