MACHINES AND
ACCESSORIES
Page 22 of 41
9 COMMISSIONING
9.1 Assembling the abrasive disc
Unexpected start-up
Before starting the assembly of the abrasive disc, always disconnect the machine from the
power outlet.
Use of PPE
Before starting the assembly of the abrasive disc, always wear suitable protective gloves.
1. Remove the work table, unscrewing the fastening lever (E) located on the left of the
table (Figure 8). Loosening the lever, the table can be pulled out and removed from
the machine.
2. Unscrew the fastening screws of the protective casing over the lower part of the disc,
then remove the casing.
3. Detach part of the rear protective sheet and attach the abrasive disc to the backing
pad, so as to align the outer perimeter of the disc with that of the backing pad (figure
11). Remove the protective sheet a little at a time and then press the disc onto the
pad.
4. Attach the protective guard over the bottom of the disc, with the two screws provided.
Tighten the screws while applying light pressure to the protective guard with the other
hand.
Figure 11 – Assembling the abrasive disc.
Backing pad
Abrasive
disc
Screws
Disc guard
fervi.com