MACHINES AND
ACCESSORIES
Page 18 of 41
7 ASSEMBLY
7.1 Assembly of the stop - piece support
1.
Place the stop - piece support (A)
on the belt and then secure it with
the screw (B) and the two washers
supplied, as shown in Figure 6.
2.
Fasten the support in position by
tightening the screw (B). To do this,
use a hex wrench.
Figure 6 – Assembly of the stop - piece support
7.2 Assembling the work table
1. Position the support of the work table
beneath the table itself and align the
fastening holes as shown in Figure 6.
2. Fasten the support to the table, using
the 3 fastening screws and the washers
supplied, as shown in Figure 6.
To do this, use a hex wrench.
3. Turn the table so that the support and
the relative fastening screws are facing
down, and then position the table in
such a way that the pin (D) present in
the support is aligned with the hole on
the machine body, as shown in Figure
7.
4. Insert the locking lever (E) of the table,
with its relative washer, into the
grooved housing for the rotation of the
table, after which screw the lever into
the threaded hole on the machine
body.
Figure 7 - Assembling the work table support.
Split washer
Hex screw
Flat screw
Support locking
screw
Support
Wrenc
h
A
B
Table
Table support
Washer (3)
Split washer (3)
Hex screw
C
C
C
fervi.com
