Operation
21
The best stroke rate setting and pendulum stroke adjustment
combination depends on the material to be machined. For determining
the ideal setting, we recommend that you always carry out a sample cut
using a scrap piece.
Switching the product on and off
The LED light
18
makes it possible to additionally illuminate the cut
surface. The LED light automatically illuminates as soon as you press the
On/Off switch
3
.
1. Insert the rechargeable battery (not included in the product contents)
2. Press the locking key
2
for the On/Off switch
3
.
The locking key can be released once switched on.
3. To switch the saw off, let go of the On/Off switch.
Sawing
WARNING!
Risk of injury!
Improper handling may result in severe injury.
− Only switch on the product with the installed saw blade.
− Only use saw blades in perfect working order.
− Immediately replace any dull, bent or cracked saw blades.
− Do not saw any curves in mitre cuts.
− Do not saw any curves in metal (exception: copper sheets).
• We recommend a narrow saw blade, which is especially designed for
cutting curves.
• First, draw a line on the workpiece that you can use as a guide. The
red line between the two locking screws (see
Fig. 1
) allows you to
guide the saw along the line you have drawn and to precisely cut the
workpiece.
1. Lay the saw shoe
7
flat on the workpiece to be machined. Switch the product on
(see chapter ‘Switching the product on and off’)
2. Let the saw blade
15
warm up until it has read full speed.
3. Move the saw slowly forward towards the desired cutting line.
4. Slowly guide the saw blade along the cutting line.