Preparation
15
Attaching the sliding shoe
1. Push the product and both retaining collars into the two recesses on the
sliding shoe
8
(see
Fig. I
).
2. Push the product downwards until the sliding shoe’s rear retaining collars click
into place.
3. To remove the sliding shoe from the saw shoe, separate the retaining collars at
the rear end of the sliding shoe and pull it downwards.
Inserting/changing the saw blade
CAUTION!
Risk of injury!
Improperly handling the product and saw blades may result in severe injury.
− Only change the saw blades when the saw has come to a stop and the
rechargeable battery has been removed.
− Only touch the saw blade with protective gloves.
− Only use saw blades with a T-shaft, see the saw blade provided, and pay
attention to the saw blade thickness that must be complied with. Other
saw blades could come out of the saw blade holder during operation.
− Pay attention to the material which is being machined when selecting the
saw blade. The saw blade length must be at least equal to the material
thickness plus 20 mm.
This product has a quick-change system so that you can insert or change the saw
blade without using other tools.
1. Set the pendulum stroke adjustment
9
to the 0 position (see
Fig. G
).
2. Open the protective cover
13
upwards.
3. Turn the saw blade holder
11
in the arrow’s direction (see
Fig. G
) and insert the
saw blade into the saw blade holder as far as it will go.
The teeth of the saw blade should be facing forward.
4. Let the saw blade holder slide back in position.
Make sure that the saw blade is firmly secured in the saw blade holder.
5. Close the protective cover downwards once again.
Make sure that the saw blade is firmly secured in the guide roller
10
.
The saw blade is removed in reverse order. Hold the saw blade firmly so that spring
pressure does not cause it to jump out.