Pag 6
NOTE:
Once the user codes are programmed, if their length is changed to a higher number of
digits than the existing codes, additional zeros will be added at the end to adapt to the new
length. If their length is changed to a lower number of digits, the existing codes will have their
final digits truncated.
This will also affect the MASTER Code and Free Access Code.
Set the user and Master code lengths (A3)
Initially, the user codes are 4 digits long, including the MASTER code. For enhanced security,
they can be changed to a length of 5 or 6 digits:
Add or edit user codes (00...99)
The codes are stored in the memory in sequence
position - code
. Up to 100 access codes
can be stored.
NOTES:
If the position to be stored is already in use, the new code will cancel the old one.
It is very important to make a list of the codes and their positions.
Master Code (1480)
A3
4, 5, or 6
1480 A3 6
1º
Enter the programming mode:
3º
Indicate the new length:
2º
Key in the option:
beep (x4)
Example
:
6-digit access and Master codes:
beep (x4)
beep (x4)
1
2
3
4
5
6
7
8
9
A
0
B
Master Code(1480)
00...99
New Access Code
1480 00 1111
1º
Enter the programming mode:
3º
Key in the new
access code:
2º
Key in the
position
in the memory
of the access code:
beep (x4)
Example:
New access code 1111 saved in
position 00.
beep (x4)
beep (x4)
1
2
3
4
5
6
7
8
9
A
0
B
Change Master code (A0)
The Master Code is necessary to enter the programming mode. The equipment comes
from the factory with a default Master Code (
1480
). To change it, proceed as follows:
1
2
3
4
5
6
7
8
9
A
0
B
NOTE:
If you forget the Master code, it is possible to reset it with the original 1480, as
explained in the "Reset Master Code" section.
Master Code (1480)
A0
New Master Code
1480 A0 1234
1º
Enter the programming mode:
3º
Indicate the new Master code:
2º
Key in the option:
beep (x4)
Example:
Programming new access
Master code: 1234.
beep (x4)
beep (x4)
(The code length must coincide with the
one set up in the system).
Содержание MEMOKEY 97023
Страница 1: ...Pag1...
