MECHANICAL INSTALLATION
Mechanical installation of the control panel consists of removing the protective paper
from the window, and physically mounting the EX 200™ Control Panel to a wall. Battery
installation is discussed in the
Electrical Installation
section of this manual.
To remove the protective paper from the window:
1. Unlatch and open the enclosure door using a flat screwdriver and remove the eleven
elastic stop nuts and the ground wire from the inside of the door.
2. Remove the window from the door and carefully peel off the paper from both sides of
the window. To avoid scratching the window, do not use a sharp instrument to
remove the paper.
3. Reinstall the window, ground wire, and the eleven elastic stop nuts. Do not over
tighten, as doing so will dimple the front of the door. We recommend tightening the
stop nut until it bottoms plus ¼ turn.
The EX 200™ Control Panel is designed to be wall-mounted on a flat surface. Figures 4
& 5 illustrate the slots provided for mounting the control panels. Use of all slots is
recommended. The standard control panel weighs approximately 35 pounds and the
larger one weighs approximately 59 pounds. The explosion proof control panel
(approximately 300 lbs.) is mounted in a similar fashion. A drawing of the explosion
proof control panel can be obtained from FENWAL.
Figure 4: Standard Panel Outline Drawing
Page 18
FSS/MC-519 Rev BC
FENWAL
Protection Systems
