Fenix TRC-700, Инструкция по эксплуатации

Страница: 12 / 20

12 12
ENGLISH
4. HOW TO USE
1. Place the ground support tower over a firm
and flat surface on its working place.
2. Remove the outriggers (A) from their
transport supports (D) by pressing the safety
pins (S) and insert them into their work
position (B) checking that they are fixed by
the safety pins (S). The longest outriggers
must be placed at the front, opposite to the
winch.
3 Adjust the ground support tower vertically
using the support plates (U) by turning the
crank (E) of the regulating rod until it is
leveled, checking the stabilizing bubble level
(L) located at the base.
4. Remove the counterweight (P) from
its position and insert it into its working
position (N) using the pin (F).
5. Assemble the truss perimeter to the
sleeveblock (C) as it should be done once
the structure is raised. In case of a truss
goal-post, two ground support TRC towers
will be required, one at each end. To do a
square perimeter, four ground support TRC
towers will be required, one at each vertex.
6. Place the truss section (T1) attached to the
end of the section where the two front hinges
(G) are located. Secure the truss with the pins
and continue with all sections (T2 & T3), put
the head (V) at the end of the last section
(T3), so that the longest part of the head (V)
is above the winch.