14
Enter the PIN code of the SIM card which is inserted in the GST1 module.
Set it using the
+/- T
buttons and confirm it with the
i
button.
You can toggle among the numbers using the
+/- H
buttons
.
Thanks to this function, you don’t need to remember the PIN code of the phone card which is
inserted into the module which you connect to the central unit. After entering the PIN code into
the central unit (according to the procedure described below), connect the module which you will
then connect to the electrical network. The PIN code from the central unit will be entered
automatically into the module within approx. 3 minutes and thus the module will become active
(use the
Test
button on the central unit to speed up the activation).
3. Insert an activated SIM card into the GST module.
The SIM card holder can be
found in the back part, after the cover has been opened at the location marked by an
arrow (see page 2 of the GST1 instructions manual).
4. Interconnect the central unit and the GST1 module using a data cable (part of
the GST1 package) and then connect the module via the power supply unit to the
230 V/50 Hz electric network!
5. Test the connection is correct
using the Test button on the control unit.
The display of the central unit will show one of the following messages:
Signalizes the correct connection of the module. Signalizes the correct connection of the module and
the setting of the PIN code.
The module is not connected, mistake in the Signalizes the correct connection of the module but a
connection of the module! wrongly entered PIN code! The module must
be disconnected; RESET the control unit
and set the PIN code correctly!