13
A SHORT-TERM TEMPERATURE CHANGE IN AUTO MODE
You can use this function in cases when the current room temperature
is unsuitable for you at a given moment and you need to make a short-
term change, without any further interventions in the programme.
This function is possible in the AUTO mode; you can set a different
temperature than the one set in the programme simply by pressing the
+/- T
buttons. BPT-SP will maintain this temperature until a further
change given by the programme.
RESET
Use the R button only in the case of a non-definable mistake – the processor will be reset after it
has been pressed, but all saved changes will be preserved in the E-EPROM memory!
If you want to clear all set parameters and programmes (programmes 3 to 9 will return to their
factory setting), press the Off button and the R button, release the R button and subsequently
the Off button.
NON-FREEZE MODE
If the room temperature sinks below
3°C, BPT-SP will automatically send an order to switch
on the boiler.
As soon as the temperature increases, it will return back to the set mode.
CONNECTION OF THE GST1 MODULE
You can add a GST 1 GSM module to the system, which will enable remote control of the control
unit via a mobile phone. With simple text messages, you can control the heating or obtain
information about the status. For more detailed instructions, see the GST 1 module (you can
select the connection options for the module via CONST 11 – 13, page 10).
DESCRIPTION OF THE SETTING WHEN THE GST1
MODULE IS USED
THE FOLLOWING PROCEDURE MUST BE ADHERED TO IN ORDER
TO BRING THE MODULE INTO OPERATION CORRECTLY!
1.
Carry out the installation and setting of the central unit according to
the instruction manual.
2.
Constants 11, 12 and 13 must be set on the control unit in the
following way:
SELECTION OF CONTROL VIA A GSM MODULE - CONST 11
Select
GSM: A
using the
+/- T
buttons and confirm it with the
i
button.
ENTERING YOUR PHONE NUMBER - CONST 12
Enter a phone number in the international format (420123456789) at which
you wish to
receive return text messages
about the status of the thermostat.
Set it using the
+/- T
buttons and confirm it with the
i
button.
You can toggle among the numbers using the
+/- H
buttons.
ENTERING THE PIN CODE OF THE SIM CARD USED- CONST 13