Femi 787XL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 60

EN
14
6.2 ASSISTENCE
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case of
repairs, under guarantee or at a later date, you should always
contact an authorized service centre or the factory directly, if
there is no service centre in your area.
6.3 DISPOSAL OF THE MACHINE AND PACKAGING
INFORMATION FOR USERS
In accordance with art. 13 of Legislative Decree
25th July 2005, no. 151 “Implementation of
Directives 2002/95/EEC, 2002/96/EEC and
2003/108/EEC, relative to reducing the use of hazardous
substances in electrical and electronic appliances and the
disposal of waste”, please take note of the following:
• The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
• The user must consign the unwanted appliance to
an authorized differentiated waste disposal centre for
electrical and electronic goods, or alternatively, hand
it over to the relative dealer on purchasing a new
appliance of the same type on the basis of a one to
one ratio.
• Differentiated disposal, to enable possible recycling
or environmentally compatible elimination of the
appliance, helps to limit undesirable effects on health
and the environment and promotes the reuse and/or
recycling of the materials which went into making up
the appliance.
ATTENTION: Sanctions, in accordance with the
relative legislation in force in the country of use,
will be imposed on the user if the appliance is
disposed
5 ACCESSORIES
5.1 CHOISE OF BLADE
Your band saw is fi tted with a bimetallic blade which handles
most cuts possible with this machine.
BENCHTOP BAND SAW
MATERIAL .................. M42 (steel for springs ÷ steel HSS)
EXTENSION: .......................................................mm 1735
HEIGHT: ...................................................................mm 13
THICKNESS:...........................................................mm 0,9
TOOTHING: .................................................... 6 - 6/10 - 14
WHEEL-MOUNTED BAND SAW
MATERIAL .................. M42 (steel for springs ÷ steel HSS)
EXTENSION: .......................................................mm 2140
HEIGHT: ...................................................................mm 19
THICKNESS:...........................................................mm 0,9
TOOTHING: .................................................... 6 - 6/10 - 14
5.2 FITTING THE BASE PLATE (Fig. 3) (where
included) - BENCHTOP BAND SAW
The fasten the machine to the base plate, use the four screw
A , four nuts B and four Washer C conteined in yhe carton
box of the base plate.
Put the four screws
A into the holes of the base of the
machine, and fasten the whole with the four nuts B .
6 MAINTENANCE
6.1 REGULAR MAINTENANCE
The operations of ordinary maintenance, which may also be
performed by non-specialist personnel, are all described in
the previous sections and here below.
1. Before performing any maintenance operation,
disconnect the machine electric plug from the wall
outlet.
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting area
and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
ATTENTION: Do not use jets of compressed air
.
4. If you do not intend to use the sawing machine for a
long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade
so that it is not kept tight for no reason.