User Manual
29 January 2018
7
FELIX Pro 2
www.FELIXprinters.com
Printer calibration
1.
The hot-ends heat up to 185
˚
C.
2.
The printer homes all axes.
3.
The Extruder moves to a certain position and probes both extruders a couple of times.
How to do the z-height calibration?
Please consult the quick start manual for further instructions.
7.1.3
XY- calibration. Adjusting the x, y distance between two hot-ends. (assisted)
The distance between two extruders need to be calibrated properly in order for a dual head print to successfully
finish. If this is not done properly printed lines from both extruders might overlap too much and cause a printed
failure.
When to do this?
-
After exchanging/servicing a hot-end
-
When adjacent features printed with both extruders do no not properly aligning.
How to do the XY calibration?
E1: 22°C E2: 22°C B: 21°C
After booting up, go to the main menu by pressing
the blue button.
Then go to Control and insert PLA filament for both
hot-ends.
Back
Dual Preheat/Cool
Remove Build PLT.
>Change filament
Level Buildplate
E1: 22°C E2: 22°C B: 21°C
Back
Dual Preheat/Cool
Remove Build PLT.
Level Buildplate
>Calibrate Extruders
Go to calibrate extruders and choose Calibrate XY
The routine will print lines with both extruders
1
2
E1: 22°C E2: 22°C B: 21°C
Choose the Best
Aligning XY Values
>X Value
8
Y Value
3
Continue
Go to calibrate extruders and choose Calibrate XY
The routine will print lines with both extruders. Now
choose the best aligning values for X and Y and
press Continue.
Note: In case the values go out of range simply
select the best aligning value and repeat the steps.
3
4
