Felder G 200, Руководство по эксплуатации

Страница: 17 / 48

17
!
"
#
$
& / (
BM ) BL
BN
%
!
"
#
Edgebander with glue pot
G 200 / G 220
Your machine is equipped with a security switch.
The machine can only run when the switch is closed.(shut
workpiece feeding unit)
Tilting away:
1.
Switch the machine off and ensure that it cannot be
switched on again.
2. Loosen the thumb screw.
(Anti-clockwise - up to stop)
3. Release the clamping lever.
Prepare the machine to operate:
1.
Close workpiece feeding unit.
2.
Clamp the clamping lever.
3. Tighten the thumb screw.
(Clockwise - up to stop)
!
Safety break switches
"
Thumb screw
#
Clamping lever
Thermoregulator to control the temperature of the glue
pot with double display
!
Operating temperature (SP1)
"
Stand-by temperature (SP2)
§
Digital temperature indicator
$
“+” and “–” set the value desired for SP1 and SP2
%
Enter key
Choice switch ON/OFF
ON: Active: LED lights up
OFF: Deactivated: Light off
&
Guillotine unit
ON: Edge roller
OFF: Strip material
/
End trimming unit
(
Heated guide ruler (Option G300)
Start/Stop buttons for the unit
)
ON: Feed rate and Flush trimming unit
BL
Start Buffing unit (Option G300)
BM
OFF: Stops all the functions started by 7-8
BN
EMERGENCY STOP button
Stops immediately all functions. Hold back type,
that is to say, once it has been pushed in it stays
in blocked position; to reset to normal position it is
necessary to pull it. N.B.: Even if possible to use it to
stop machine in normal functions it is unadvised.
Assembly
Fig. 7: Electrical operation
5.3 Electrical operation
Fig. 6: Electrical operation
5.4 Safety devices - Safety break switches