WSG 8-115 / WSG 13-125 / WSG 9-125 / WSG 13-125 S
WSG 13-150 / WSG 9-70 E / WSG 13-70 E
21
EN
weight. Supports must be placed under the
workpiece near the line of cut on both sides of
the cutting wheel and at the ends of the work-
piece.
Use extra caution during “plunge cuts" in walls or
other blind areas.
The penetrating cutting wheel
may cut gas or water conduits, electrical wiring
or objects that could cause kickback.
Safety instructions, particularly for sanding
work with a sanding disc.
When sanding, do not use an excessively oversized
sanding disc. Follow the manufacturer’s recommen-
dations when selecting sanding discs.
Sanding discs
larger than the backing pad present a laceration
hazard; they can tear, cause snagging, rip off from
the backing pad or cause kickback.
Special safety instructions for sanding work
with wire brushes.
Be aware that wire bristles are thrown by the
brush even during normal operation. Do not over-
stress the wire bristles by applying excessive load
to the brush.
The wire bristles can easily pene-
trate light clothing and/or the skin.
If the use of a guard is stipulated for sanding with
wire brushes, do not allow the wire bristles to con-
tact the guard.
The wire brush may expand in
diameter due to the work load and centrifugal
forces.
At a glance.
The following numbering used for the
operating elements relates to the figures
at the beginning of this Instruction Manual.
1 Locking button
Lock the drive when changing the grinding
tool.
2 Speed regulation button
For setting the speed to different levels.
3 Speed display
Display with symbols showing the different
speed levels.
4 Pressing surface (4x)
For starting the angle grinder.
5 Threaded flange
Attaching or changing the grinding disc.
6 Auxiliary handle
Hold the power tool with both hands.
7 Wheel guard with fast adjustment
Locking lever (7a) for releasing/locking the
wheel guard.
8 Wheel guard with tightening screw (8b)
For loosening/tightening the guard.
9 Standard accessories
Auxiliary handle (9c),
Wheel guard with fast attachment (9d)
WSG 8-115/WSG 13-125,
Wheel guard with tightening screw (9e)
WSG 9-125/WSG 13-125 S/WSG 13-150/
WSG 9-70 E/WSG 13-70 E,
Threaded and inner flange (9f),
Face spanner (9g).
Only part of the accessories described or shown
in this instruction manual will be included with
your power tool.
Intended use of the power tool.
This power tool is intended as a hand-guided
grinder for commercial use, for dry-sanding/
grinding and cutting metal and stone in weather-
protected environments using the application
tools and accessories recommended by FEIN.
Operate the power tool only with the voltage
rating as printed on the nameplate of the
machine.
This machine is also intended to be powered by
a.c. generators with sufficient power output that
correspond with ISO 8528, design class G2.
Compliance with this Standard in particular is
not given when the so-called distortion factor
exceeds 10%. When in doubt, inform yourself
about the generator in use.
Operating instructions.
Mounting the auxiliary handle (Figure 6).
➤
Screw the auxiliary handle tightly onto
the left or right side of the power tool,
depending on the working method.
3 41 01 050 06 0.book Seite 21 Dienstag, 12. Juni 2007 10:57 10
