Fein JCM 200QX, Инструкция по эксплуатации

Страница: 16 / 77

16
en
Changing the tool (figure 8).
When there is danger of fall-
ing down, secure the
machine using the provided safety strap;
especially when working aloft, on vertical
building elements or overhead.
In case of a
power failure or when the mains plug is
pulled, the magnetic holding power is not
maintained.
Before mounting or replacing
cutting tool or accessories,
pull the power plug. This preventive safety
measure rules out the danger of injuries
through accidental starting of the power
tool.
Core drill bit
Insert the pilot pin into the cutter.
Pull the clamping sleeve of the tool holder
down and insert the core drill bit with the
centering pin into the tool holder.
Do not touch the sharp edges of the core drill
bit.
Danger of injury.
Drill chuck
Pull the clamping sleeve of the tool holder
down and insert the drill chuck.
Drill bit
The knurled nut has a left-hand thread; turn
clockwise to release!
Loosen the knurled nut and remove the tool
holder by applying a hammer blow to the
positioned drift.
Clean the inside cone of the output shaft and
insert the drill bit.
WARNING
WARNING
MT 3
CM 3
Drill chuck
Drift
Drill bit
Clamping sleeve
JCM 200 U, JCM 200 auto, JCM 256 U
Knurled
nut
Centering pin
Core drill bit