IDENTIFICATION
ID CPR60
Page 17 of 22
The manufacturer is obliged to test the terminal equipment
without
RF transmitter, according to the national
FCC requirements according to 47 CFR Part 15 Subpart B. For this purpose, the HF transmitter of the reader
module must be switched off. The HF transmitter is switched off by the SW command: Transparent
Command - HF Off HEX: 06 FF 6A 00
FCC-/IC-NOTICE: To comply with FCC Part 15 Rules in the United States / with IC Radio Standards in
Canada, the system must be professionally installed to ensure compliance with the Part 15 certification / IC
certification. It is the responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States / Canada.
Antennas Approved in the USA (FCC) and Canada (IC)
Following antennas are approved by FCC according FCC Part 15 and IC Canada according RS210:
•
ID ISC.ANT100/100
(100 mm x 100mm)
•
ID ISC.ANT40/30
(40 mm x 30mm)
•
RFID Antenna Board 445-100302
(30 mm x 30mm)
A coaxial cable, U.FL-LP-088, is used to connect the antenna. The antenna cable should be no longer than
1,0 m. The use of other cable length are possible after consulting the manufacturer.