Feig Electronic Sensors VEK CN1-1, Руководство по эксплуатации

Страница: 5 / 16

Operating Instructions VEK CN1-1
FEIG ELECTRONIC GmbH 12/11 5
1.2 Operating Modes
The counting unit can be operated in mode “Open Space Counting” or in mode „Passing Vehicle Counting“. The
choice of operating mode occurs with set up the switching threshold. (see 2.4.1 Operating Modes switching )
Operating
Mode
set to switching
threshold
S oc
Output relay switches
at counter
reading
on output state
Open Space
Counting
0
≤
0 used
≥
HyS
free
Passing vehicle
Counting
Requested value
≥
S oc
used
≤
(
S oc
–
HyS
)
free
S_oc = adjusted switching Threshold (switch occupied)
hys = adjusted Counter Hysteresis (see 2.4.2 Counter Hysteresis)
1.2.1 Operating Mode “OPEN SPACE COUNTING”
The “OPEN SPACE COUNTING” is preferably used when the counting reading of the parking spaces is done
when the car-park is full so less open spaces has to be counted. Vehicles leaving the car-park will increment the
counter (Input 1) and vehicles entering the facility will decrement the counter (Input 2). The counter will activate the
output relay whenever the open space counter is equal or less than “0”. The output relay will be released as soon
the counter reached the adjusted counter hysteresis.
1.2.2 Operating Mode “PASSING VEHICLE COUNTING”
The “PASSING VEHICLE COUNTING” is preferably used when the counter reading of the parking spaces is done
when the car-park is empty so less occupied parking spaces must be counted. Vehicles entering the car-park will
increment the counter (input 1) and vehicles leaving the facility will decrement the counter (input 2). The counter
will activate the output relay whenever the vehicle counter reaches or is higher than the adjusted maximum. The
output relay will be released as soon the counter reaches or is lower than the adjusted lower counter hysteresis.
1.3 Pulse Inputs
The switching status of inputs is in normal operating mode displayed with four decimal points on the display. The
function of Inputs can be independent set on:
•
increment
•
decrement
•
reset counter or
•
no function
(see 2.4.3 Counter Level). Factory setting for input 1 and 3 is set to increment and for input 2 and 4 set to
decrement .
The inputs are interference-suppressed against switch bounces. Input pulses are counted separately of adjusted
function until 9.999.999. Each input pulse counter can be set up and reset separately. (see 2.3.4 Display and
Counter Reset).
1.4 Reset Input
With the Reset Input the counter reading can be reset to 0. The relay output will be adequate to the preferences set
on
free or used. The adjustment parameters and the input pulse counter will not be changed. Is the output state
manually set on free or used (see 2.3.3 Set Relay Output manually to “Free” or “Occupied”) so the relay will stay in
this state.