Operating Instructions
VEK CN1-1
FEIG ELECTRONIC GmbH
12/11
15
5 Safety instructions and Warnings
•
The device may only for the purpose intended by the manufacturer.
•
These operating instructions have to be handed out to every user and kept in an easily accessible
place.
•
Unacceptable changes as well as the use of spare parts and special features which are not sold or
recommended by the manufacturer may cause fire, electric shocks and injuries. Such measures do
therefore lead to nonliability of the manufacturer and a lapse of all warranty claims.
•
The appliance is subject to the manufacturer’s guarantee regulations in the version valid at the time
of purchase. We cannot be held liable for improper or faulty manual or automatic adjustment of
parameters resp. improper use of the appliance.
•
Repair work may only be carried out by the manufacturer.
•
Installation, initiation, maintenance, measuring and adjustment of the counting unit should only be
carried out by electricians with a good knowledge of the rules for prevention of accidents.
•
When handling appliances that get in contact with electricity, the valid VDE-regulations have to be
observed. In particular, these are: VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711, VDE 0860,
VDE 0105 as well as the rules for the prevention of accidents and fire VBG4.
•
Before opening the device be assure that power is turned off and re-measure if power is down.
•
If an operation display goes out, this is not a proof that the appliance is disconnected from the mains
and idle.
•
All labour that is carried out on the appliance as well as its installation has to conform to the national
as well as the local electric regulations.
•
The user has to make sure that the appliance is installed and operated according to the technical
rules of the country of installation as well as other regional regulations. Cable dimensions,
protection, grounding, disconnection, insulation control and excess current protection should be
especially considered.
•
The gold gladded relay contacts will be destroyed for switching currents higher than 100 mA. Relays
with such pre-stressed contacts can certainly switch only currents higher than 100 mA.
