IDENTIFICATION
ID LRU500i
7 Technical Data
Installation
Page 28 of 35
7 Technical Data
Technical Data
Mechanical Data
Housing
Plastic (ASA-PC)
Aluminum
Dimension (W x H x D)
290 mm x 290 mm x 100 mm
(11.4“ x 11.4“ x 3.9“)
Weight
2800 g
Mounting
VESA FDMI MIS-D 100 mm x 100 mm
Protection Class
IP 65
Colour
Anthracite, translucent
Electrical Data
Power Supply
12–24 V DC (± 10 %), PoE+
Current Consumption
typical 16 W (22 W with PoE+)
Operating Frequency
•
EU Reader
•
FCC Reader
865 MHz to 868 MHz
902 MHz to 928 MHz
Output Power
100 mW to max. 1 W
configurable in steps of 100 mW
Antenna Connection
1 x R-TNC jack (50 Ω)
(Reverse-TNC)
RF Diagnostic
RF channel monitoring,
Antenna SWR control,
Internal Overheating Protection
Outputs
•
2 x Optocoupler
•
2 x Relay (LRU500i-BD: 1 x Relay)
max. 24 V DC / 20 mA
max. 24 V DC / 1 A switching current, 2 A permanent
current
Inputs
•
2 x Optocoupler
max. 24 V DC / 20 mA
CAUTION:
Overheating of the device may result in performance losses. It is recommended to activate the RF of
the reader only if there is a transponder in the detection range of an antenna.
Interfaces
•
Version PoE
•
Version BD
Ethernet, USB (OTG)
Wiegand, RS485, USB (OTG)
Protocol Modes
•
Version PoE
•
Version BD
ISO Host Mode, Notification Mode, Buffered Read Mode
ISO Host Mode, Scan Mode
Functional Properties
Supported Transponder Types
EPC Class 1 Gen 2
EPC Class 1 Gen 2 V2
ISO 18000-6-C (upgrade code required)
ISO 18000-63 (upgrade code required)
Indicators
Signal light with red/green/blue
10 LEDs to indicate operation and antenna state
Buzzer
