OBID
i-scan
®
UHF
Installation
ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH
Page 23 of 32
M21016-3e-ID-B
Green
Yellow
Red
Description
Configurations-Reset:
FLASH
FLASH
FLASH
While T1 is pushed and hold for maximal 5s
(light in sequence)
ON
ON
ON
After T1 has been pushed and hold for 5s. Configuration
Reset has been finished.
Input / Output LED (yellow):
Configurable LED.
Can display the status of a digital input or output
ANT 1 – 4:
Green
HF Power switched on
Blue
Tag-Detect
Red
Antenna impedance error (> 50Ohm or <50Ohm)
5.2. Reset Push Buttons
Figure 19 shows the position of the reset push button’s T1 and T2.
At the right side of the connector X6 the push button T2 is positioned. With this push button a CPU-
Reset can be performed.
With the push button T1 within the reader housing on left side of X3 a complete con-
figuration reset can be performed. For performing a reset you should use a pa-
per clip and push the button T1 for at least 5 s until the 3 status LED’s (left
side) are switched on continuously, see 5.1. Status LEDs
Table 12: Configuration of the LEDs
.
Table 12: Configuration of the LEDs
Figure 19: Position of the reset-switches T1 and T2
