mr
.
steam
®
C L U B T H E R A P Y
Controls
_________________________________________________________________________________________
17
30' cable
Switch
Plug & Play
Connector
Diagram 1
Diagram 2
Diagram 3
Diagram 4
Diagram 5
Diagram 6
CT SteamStop
®
On/Off Switch for iTempo/Plus
®
Dimensional Information
Box Contents:
• CT SteamStop Control
• Owner’s Manual
• 60’ CT SteamStop Cable
IMPORTANT NOTE:
The control cables should be run in
dedicated 1" conduit to facilitate installation and service.
Installing the CT SteamStop Control
The CT SteamStop has a 60 foot cable with a Plug & Play connector at both
ends. (Diagram 1) The CT SteamStop must be installed inside the steamroom.
Step 1
Diagram 2
Drill a
7
⁄
8
inch diameter hole in
a preferred wall location. Do not oversize
or undersize the hole.
Step 2
Diagram 3
Route the cable from the wall to the steam
generator. Be careful not to strain, pinch or
otherwise damage the control cable.
Step 3
Diagram 4
Remove and discard the peel-off paper
from the switch housing to expose the
adhesive as shown in Diagram 4.
IMPORTANT NOTE:
Use care not
to apply silicone to the adhesive gasket.
The connector is keyed and will only connect in one
orientation with the tab facing up.
LED indicator will light up
when the generator is ON.
Using the CT SteamStop
®
Control
The CT SteamStop control should be installed in the steam room for
the user to start and stop the steam bath
If an error code is detected by the system the LED
indicator will flash. Refer to the iTempo/Plus or iSteam display for
error code or call a MrSteam’s service technician.
For Illustrative Purposes Only. Drawings Not to Scale
Step 4
Diagram 5
Apply silicone (
provided with the
iTempo/Plus control)
to the hole in
the wall as required to create a
moisture seal. Apply silicone to
the back of the switch as required
to seal grout lines or as required
for additional adhesion.
Step 5:
Push cable and switch
housing into the hole firmly.
Step 6
Diagram 6
Firmly connect the Plug & Play
connector to the steam generator
connector labeled CT SteamStop.
Care Tips for all Controls and Steamheads
1. Use only mild soap and water on a soft cloth to clean the control
and steamhead.
2. Do not use abrasive cleansers.
3. If the decorative cover is damaged on the iTempo/Plus
call MrSteam technical service for replacement parts.
Replacement of the decorative
covers requires removal and reinstallation of
the control from the mounting surfaces.
