Federal Signal Corporation Valor FSJoin, Инструкция по установке, обслуживанию и ремонту, Страница: 14 / 40

14
Valor
®
Light Bar
Federal Signal
www.fedsig.com
Preparing the Valor for Installation
Identifying the Control Wires for Flash Patterns
This section describes how to program flash patterns by applying 12 Vdc to the
control wires in the 24-pin harness of Serial Interface Module. Table 4 shows the
control wires and colors. The first color is the predominant color, and additional colors
are stripes.
Table 4 Control wires from the Serial Interface Module with Default Programming
Light Bar Controls Wire Color Description
Mode 1 Blue Lowest priority.
Mode 2 Blue/White Overrides Mode 1.
Mode 3 Black/Red Overrides Modes 1 and 2.
Steady Burn
(HotFoot only)
Red/White One or more LEDs steadily burn when 12 Vdc
is applied to the control wire for a Mode and the
control wire for Steady Burn.
Front Cutoff
Green/White
Turns off the front of the light bar.
Front Enable Turns on the front of the light bar.
Rear Cutoff
Orange/Black
Turns off the rear of the light bar.
Rear Enable Turns on the rear of the light bar.
Low Power White/Black/Red Dims the lights approximately 50 percent to
prevent blinding approaching drivers. Low Power
is only available in Modes 1 and 2 and is disabled
when switched to another flash pattern, including
Mode 3 and Intersection.
Flash Takedown/Alley Red/Black Flashes the alley and takedown lights in Modes 1,
2, or 3.
Left Alley Green/Black Turns on left alley lights. Overrides the Flash
Takedown/Alley lights.
Right Alley Orange/Red Turns on right alley lights. Overrides the Flash
Takedown/Alley lights.
Takedown White/Black Provides white light to the front. Overrides Flash
Takedown/Alley lights and front cutoff.
Scene Light, Left Blue/Black Applying 12 Vdc to the Scene Light, Left wire turns
on the left half of the light bar.
Scene Light, Right Black/White/Red Applying 12 Vdc to the Scene Light, Right wire
turns on the right half of the light bar.