31
Installation
Description, Specifications, and Installation Manual
General Mounting Guidelines
Use good installation methods and follow local ordinances for mounting
cabinet.
These general installation instructions are pertinent to all installations. Specific mounting
methods and required installation materials are described in the next section.
1. There are two keyhole type slots and two pre-drilled holes for mounting, located on
the back panel of the cabinet. (See Figure 5.)
2. The total weight of the UVRI-B cabinet with batteries is listed in the Specifications
section. It is important that the mounting surface and mounting method selected can
safely sustain the weight of the assembly.
3. Prepare the mounting surface for hanging the cabinet by predetermining the location
of the mounting holes. Attach the cabinet to a wall or other substantial vertical
surface.
If the mounting surface is not flat, the cabinet may require shimming to keep the
cabinet square.
4. Guidelines for various attachment methods to accommodate different wall types are
described in the following section. Make provisions for spacing behind the cabinet
when mounting to an exterior wall that is susceptible to condensation or other surface
moisture.
5. Use two people to lift the cabinet to the desired mounting height and lag to the wall
using the prepared holes and anchors.
6. If the UVRI-B model being installed has a two-way radio, ensure the radio power
switch is turned off until all wiring is completed to avoid damaging the radio.
UVRI-B Installation Material List and Installation Guidelines
The following material lists and guidelines describe basic installation details required
to install the UVRI-B cabinet. This list varies depending on mounting methods, other
options, local and national electrical codes, etc. Use list as a reference guideline only.
Concrete or Filled Cement Block Wall Mounting Guidelines
Table 24 Concrete or Filled Cement Block Wall Mounting Materials
Material Description
Purpose
Qty
1/4 in x 2 in Pin/Sleeve/
Lock Washer/Nut Style Anchors
Anchor Bolts 4
1. Mark the mounting hole locations on the wall for the cabinet.
2. Install the anchor bolts for the four cabinet corners according to the manufacturer’s
instructions.
3. Mount the cabinet to the wall.
